For low-alloy high-strength steel with a yield strength of around 690 MPa, use HILCO K80, a solid wire to AWS A5.28 ER 110 S-G. This type of steel is used where structures must remain light yet carry heavy loads.
Why build light to be strong
With lifting and hoisting equipment, the dead weight works against you. A crane that already weighs twenty tonnes by itself can lift less because its own mass gets in the way. The same applies to scaffolding and frames: if you make them heavy in relatively weak steel grades, the structure becomes unwieldy and more expensive.
The solution is to build thinner with stronger material. Low-alloy high-strength steels derive their strength from a low alloy content in combination with a specific production process. They are readily weldable, provided you take the right precautions.
What to monitor during welding
The strength and toughness of high-strength steel derive from its microstructure. That structure must remain intact after welding. Excessive heat input or an incorrect interpass temperature affects that structure, causing you to lose precisely the property for which you chose this steel.
- Keep the heat input within the specified limits
- Monitor the interpass temperature between the passes
- Use low-hydrogen filler metals to prevent cold cracking
- Make sure the weld joint is clean and dry
The range for this application
Product AWS Form Application K80 A5.28 ER 110 S-G Solid wire, MAG High-strength steel with yield strength approx. 690 MPa Fer SGNi1 A5.28 ER 80S-Ni 1 TIG rod Fine-grained steel with impact toughness requirements Basic A5.1 E 7018-1 Covered electrode Structural work on thicker plates Basic Super A5.1 E 7018-1 Covered electrode Structural work on AC and DC For structural work on thicker plates with requirements for toughness and strength, the basic electrodes Basic and Basic Super remain the starting point. K80 comes into play as soon as the base material actually falls into the high-strength class.
Where you will come across this
High-strength steel is used in pressure vessels, mobile cranes, lifting equipment and vehicle frames. It also plays a role on the structural side of the petrochemical industry: a refinery consists not only of pipes and boilers, but also of large amounts of steel structure. Read more about this on our heavy fabrication page.
What matters in inspection
Structures made of high-strength steel are often subject to an inspection regime. A pressure vessel that fails or a crane that collapses can have major consequences. The designer therefore draws up a welding procedure that specifies which base materials and which welding consumables may be used. Both must be certified and the welder must be qualified for the work concerned.
Always check which steel grade is stated on the drawing. Designations differ per standard, with old DIN designations and new EN designations in circulation side by side.
Send us the steel grade and the plate thickness, and we will advise you on the appropriate filler metal.














