In critical structures, the entire chain must be demonstrably in order, from the base material to the welding consumable and the qualification of the welder. Approval by an independent classification society closes that chain and establishes responsibility.
When certification is mandatory
As soon as the failure of a structure could endanger lives, strict requirements apply. Think of a bridge, a crane, a pressure vessel, a grandstand or a ship's hull. In the design phase, the engineer must already take into account the requirement that the welding consumables carry an official approval. If you use products that have not been approved, you run the risk of the entire structure being rejected.
In Europe, this is regulated through CE marking. The associated standards are monitored by bodies that operate independently of the manufacturer.
Which bodies carry out these checks
Body Used for Lloyd's Register Shipbuilding and maritime structures ABS Shipbuilding and offshore DNV Shipbuilding, offshore and industry TUV Pressure and structural applications The chain must be complete
This is most clearly visible in shipbuilding. No ship is built with electrodes or wires that have not been approved by an independent inspection body. If you nevertheless use products that have not been tested or approved, the ship itself will not be approved either. The same logic applies to other critical structures: the steel, the fasteners, the welding consumables and the qualification of the welder must all be demonstrably in order. If one link is missing, the chain is not complete.
This also has a legal side. If a designer chooses a brand that has been approved by an independent party, responsibility on that point is covered. Should something go wrong after all, it can be demonstrated that the right choices were made at every point in the process.
These societies do not only approve the end product. They also inspect the preceding process and the factories where production takes place. The approvals are reassessed at fixed intervals, making it not a one-off action but an ongoing obligation.
What you receive from us
For products intended for critical applications, we supply a quality certificate. It states what we measured before the product was packed: the chemical composition, the expected hardness, the toughness and the strength. This allows you to demonstrate that the filler metal matches the base material you are welding. Read more about this under material test certificates.
Our abrasives are standardised as well. The Hilco Hildiscs are produced in accordance with ISO 9001 and EN 12413 and meet the requirements of the Organisation for the Safety of Abrasives.
Weighing up the costs
A certified electrode may cost slightly more per kilo than an uncertified alternative. Compare that difference with the costs incurred when a structure is rejected, a repair has to be redone or damage occurs. So do not only look at the price per kilo, but at the total cost of the application, including the consequences if something goes wrong.
A more detailed discussion of this topic can be found in our article why certified welding consumables matter for critical constructions.
Do you need certificates for a specific project? Contact us and we will find out which approvals apply to your application.














