No. Some electrodes only work on direct current, others on both alternating current and direct current. Always check the type of current and the polarity on the data sheet before you use an electrode, because the wrong combination results in an unstable arc and a poor weld.
Alternating current and direct current
In the past, a lot of welding was done with transformers on alternating voltage. That is an inexpensive, low-maintenance way of welding that served well for many years. Modern companies work with direct current, generated by rectifiers or inverters. This equipment is more compact, lighter and delivers a more stable arc.
An electrode that is suitable for both types of current has a broader range of use. If you work exclusively with direct current, you can also choose an electrode that is specifically designed for it. So it is a matter of matching what is available in your workshop.
How to read the designation
Designation Meaning AC Alternating current DCEP Direct current, electrode on the positive pole DCEN Direct current, electrode on the negative pole The data sheet states which type of current and polarity we recommend. With direct current, the order indicates the preference. The recommended amperage per diameter is also stated. More explanation on reading this data can be found under a typical data sheet.
What this means for your choice
- If you have several machines or the power source changes per location, choose an electrode that works on AC and DC
- If the entire workshop runs on direct current, you do not need that extra flexibility
- With older transformers, check the open-circuit voltage, some electrodes require a minimum of 42 volts
- Take the available power into account with larger electrode diameters
Wire processes have different requirements
If you want to work with MIG, MAG or TIG, you need a wire feeder and a gas supply in addition to a power source. For TIG you also need a torch and a tungsten electrode. You will find these, together with welding cable, anti-spatter gel and gouging rods, among the accessories.
When setting up your workshop, bear in mind that wire processes are used indoors and covered electrodes outdoors as well. A workshop that has to cover both situations therefore often has both types of equipment.
The equipment partly determines the range
In workshops where the equipment needs to stay simple, electrode welding is often the practical route. You only need a power source and an electrode holder, the learning curve is limited and the electrodes can be used straight from the packaging. Where investment has been made in wire feeders and gas supply, the emphasis is on productivity and a wire process is the logical choice.
Both situations occur side by side, sometimes within the same company. That is why we supply many products in both an electrode and a wire version, so that you do not have to choose between the right product and the available machine.
The documentation for our welding machines can be found under welding machines documentation.
We are happy to think along with you about matching your equipment and your welding consumables.














