Both are brass-based brazing rods with low fume emission. Bronze C is a bare rod used with a separate flux, while Bronze F has a flux coating and does not need a separate flux.
The practical difference
Feature Bronze C Bronze F AWS A5.8 approx. RB CuZnC A5.8 RB CuZn-C Flux Applied separately Applied to the rod Length 1000 millimetres 500 millimetres Diameters 1.5 to 6.0 millimetres 2.0 to 3.0 millimetres Packaging Boxes of 5.0 kilos Boxes of 2.5 kilos Bronze F is more convenient to use because you do not need to carry or apply a separate flux. That saves handling, especially when working on site. Bronze C gives you more freedom in the choice of flux and is available in a larger diameter range. For Bronze C, HILCO supplies a matching Bronze Flux.
What you use them for
Both products are suitable for joining and surfacing steel, copper and copper alloys, brass, grey and malleable cast iron, nickel and nickel alloys. They produce pore-free joints in a colour that closely matches brass, which is an advantage for visible work.
An important feature is that you can join galvanised steel with them without damaging the zinc coating. During welding, the zinc coating evaporates around the joint, after which the corrosion protection at that point is gone. Brazing takes place at a lower temperature, so the zinc coating largely remains intact.
Why low fume emission matters
Brass contains zinc, and zinc evaporates when heated. The designation low fuming means that the composition has been chosen so that less fume is released. That makes the work more pleasant and reduces the exposure of the welder. Good fume extraction and personal protection nevertheless remain essential. For this, see the safety data sheet of the product and our range of personal protective equipment.
When to choose silver brazing
If the joint has to be made at an even lower temperature, or if you work with thin components and fine work, the silver brazing rods are an alternative. These are widely used in refrigeration and installation work.
Difference from welding
In brazing, the base material does not melt. The filler metal flows over the heated surface and bonds to it. As a result, the heat input remains lower than in welding, which limits distortion and leaves the properties of the base material largely intact. That is an advantage for thin components and for materials that do not tolerate high temperatures well.
On the other hand, a brazed joint has different strength properties from a welded joint. For load-bearing structures with high requirements, welding is the preferred route. For joining dissimilar materials, for pipework and for repair work on thin parts, brazing is often the better choice.
We are happy to advise you on the choice between welding, brazing and soldering for your application.














