For cutting through material, use a cutting disc; for removing material, a grinding disc; for levelling and finishing welds, a flap disc; and for cleaning and conditioning a surface, a Hilblend blending disc.
The four types at a glance
Type Operation Suitable for Flat cutting disc Cutting Steel and stainless steel Depressed centre cutting disc Cutting with depressed centre Steel and stainless steel Grinding disc Removing material Steel and stainless steel Flap disc Levelling, deburring and finishing Steel, stainless steel and aluminium Hilblend Cleaning and conditioning Steel, stainless steel and aluminium How the types differ
Cutting discs are thin, from 1.0 to 3.0 millimetres, and are intended to cut through material. Grinding discs are thicker, usually 6.4 millimetres, and are intended to remove material. Both consist of abrasive grains bonded with resins and fillers and reinforced with glass fibre.
Flap discs work differently. They consist of overlapping flaps of abrasive cloth. The zirconia grain breaks down in a controlled way during use, constantly creating new sharp cutting edges. As a result, performance remains consistent over the life of the disc. HILCO flap discs have a conical design on a fibre backing pad, intended for grinding at an angle of 15 to 25 degrees.
The Hilblend blending disc is made of thick synthetic fibres with an extra coarse grain. The open structure cuts fast without clogging. The disc removes, levels and conditions in a single operation, without removing excessive base material.
Typical applications
- Removing surface rust, corrosion and mill scale with Hilblend
- Removing light weld spatter and contamination without affecting the plate
- Removing paint and epoxy coating in preparation for a next operation
- Levelling welds and bevelling edges with a flap disc
- Removing burrs after cutting
What to consider when choosing
Pay attention to the diameter, the thickness and the bore size, so that the disc fits your machine. Also check that the disc is suitable for the material you are working on. With stainless steel, it is important that the disc does not leave ferrous contamination, because that can later cause rust.
Where the discs are used
Abrasives are used in virtually every sector where metal is worked. In the petrochemical industry, the food industry, shipbuilding, construction and repair and maintenance, they are part of daily work. They are often used in combination with welding: first cutting, then welding, then levelling and finishing the weld.
In hardfacing, a disc is even part of the process. The weld metal of hardfacing products is so hard that it can only be finished by grinding. Turning or milling is not possible. Allow for this in your work preparation.
HILCO Hildiscs are produced in the Netherlands. The complete documentation can be found under abrasives documentation.
We are happy to help you put together the right range of discs for your workshop.














