The root pass is welded with TIG because that process provides clean, sealed penetration. For the fill passes, the welder switches to MIG because that process is faster. This way, you combine the quality of TIG with the productivity of MIG.
What each process does well
In TIG welding, the welder has a great deal of control over the weld pool and the heat input. That is exactly what you need for the first pass of a pipe joint, where the weld must penetrate the full wall thickness and the inside must remain smooth. For thin-walled material, TIG is the preferred process for the same reason.
Once the root pass is in place, the task changes. The joint has to be filled, and that should be done as efficiently as possible. MIG welding deposits more material per unit of time and works continuously from a spool, without the interruptions that do occur with electrodes. For the fill passes, that is the logical choice.
Which products to use
Pass Process Product for 316 grade Product for 308 grade Root pass TIG Hilchrome W316L Hilchrome W308L Fill passes MIG Hilchrome G316LSi Hilchrome G308LSi Alternative, all passes Covered electrode Hilchrome 316R Hilchrome 308R It is important to stay within the same alloy class. When you switch process, you change the form of the filler metal, not the chemical composition.
When you do use electrodes
Covered electrodes are still widely used in the process industry. If you work outdoors, or if the location is difficult to reach for a wire feeder, a gas-shielded process is ruled out. Stainless steel joints are then simply welded with a HILCHROME electrode.
The scale of the work also plays a role. For a few centimetres of weld on a small crack, you do not haul in a wire feeder and a gas cylinder. For a boiler or series production, on the other hand, you do choose a mechanised process, because an electrode costs too many man-hours there.
Points of attention for the combination
- Clean the root pass before you start filling
- Monitor the interpass temperature in accordance with the welding procedure
- With stainless steel, use a separate set of tools to prevent iron contamination
- Check that the choice of gas suits the process and the alloy
The choice of welding process is ultimately a decision for the designer or the responsible welder on site. We make sure that a suitable filler metal is available for each of these processes.
Why this is a question of productivity
The underlying consideration is always the same: where do you need control and where do you need speed. For the root pass, the quality of the penetration counts, because it determines whether the joint is sealed across the full wall thickness. For the fill passes, what counts is the amount of material you deposit per hour. By choosing the appropriate process for each pass, you get the most out of both without compromising the quality of the joint.
We are happy to help you put together the right combination for your welding procedure.














