The choice depends on the type of wear. For abrasive wear with impact, choose HILCO Hardmelt 600, for heavy abrasion with moderate impact Hardmelt 638, and for sliding wear with heavy impact Hardmelt 620. If you work with wire, HILCO H-600 and HILCO Hilcord 600 are the counterparts.
First determine the type of wear
Wear occurs in different forms, and these call for different solutions. Look at what actually happens to the component in practice and what function it has.
- Metal to metal, with rolling or sliding parts with little lubrication
- Heavy impact, where the surface is crushed or cracks
- Abrasion combined with impact, with granular material under impact loading
- Heavy abrasion, where granular material grinds the surface away
- Metal to soil, with earth and sand and moderate impact
- Corrosion, where chemical attack plays a role
The range per situation
Wear situation Covered electrode Wire Moderate abrasion, high impact Hardmelt 600 H-600 or Hilcord 600 Heavy abrasion, moderate impact Hardmelt 638 On request Sliding wear, heavy impact Hardmelt 620 H-600 Sliding wear with corrosion Hilchrome 312R or 307R On request Buffer layer before hardfacing Hilchrome 312R On request The technical data
Product Classification Hardness Special feature Hardmelt 600 DIN 8555 E 6-UM-60 approx. 600 HB Basic coated, for steel, cast steel and high manganese steel Hardmelt 620 AWS A5.13 E Fe 5-B mod. See data sheet Rutile coated, up to approx. 550 degrees Celsius Hardmelt 638 EN 14700 E Z Fe14 See data sheet High efficiency, 205 percent recovery H-600 EN 14700 S Fe8 approx. 600 HB Solid wire, martensitic structure Hilcord 600 DIN 8555 MSG 6-GF-60-GP approx. 600 HB Seamless metal-cored wire The weld metal of these products is martensitic and so hard that it can only be finished by grinding. Turning or milling is not possible. Take this into account in your work preparation.
Points of attention when welding
- Preheat crack-sensitive base materials and apply a buffer layer first
- Monitor the interpass temperature in accordance with the instructions on the data sheet
- Determine in advance how many layers are needed to return to the original dimensions
- Bear in mind that the last layer is the wear-resistant layer
Electrode or wire
Both forms are used side by side in practice, and that has to do with the workplace. If the component is treated in a workshop, you work with wire. That is a continuous process without the interruptions that occur with electrodes, which makes a big difference on larger surfaces. If the component has to be repaired in the field, for example a machine that cannot be brought indoors during the season, you use an electrode because gas shielding does not work there.
The same installation therefore sometimes requires both versions. A factory repairs the rollers and internal components indoors with wire, and the machines that work outdoors with electrodes.
The classification according to EN 14700 is explained under classification EN 14700. The data sheets can be found under repair and maintenance documentation.
Describe the wear situation and the base material, and we will advise you on the build-up of the weld layers.














