You select the welding consumable based on three factors: the base material you are welding, the welding process you use and the conditions under which the structure will have to perform. The starting point is matching welding, where the filler metal corresponds to the base material in composition and properties.
Start with the base material
The first question is always which material lies beneath the weld. Unalloyed steel, low-alloy steel, stainless steel, aluminium and non-ferrous metals each have their own requirements. For a stainless steel pipeline, you look for a filler metal with a comparable chemical composition, so that the welded joint retains the same corrosion resistance as the rest of the installation. For cast iron, on the other hand, you work with nickel-based products, because matching welding is not possible there.
Identifying the base material is the job of the designer, the welder or the person responsible on site. If the steel grade is stated on the drawing or the certificate, the choice is usually quickly made. If that information is missing, read the question on welding without knowing the material.
Then determine the welding process
The welding process determines the form of the filler metal. For covered electrodes, you choose from the stick electrodes range; for mechanised welding, from the MIG/MAG wires or the TIG rods. For gas welding and brazing, there is the brazing rods range.
The working environment plays a part in this. Gas-shielded processes are difficult to use outdoors, because the wind blows the shielding gas away. If you are working outdoors, a covered electrode is the obvious choice. In a workshop or assembly hall, a wire process is usually the logical choice.
Finally, consider the load in service
A welded joint must do what the structure demands of it. Relevant questions are: is the component under pressure, does it operate at elevated temperature, does it come into contact with acids or abrasive media, and are there requirements for impact toughness at low temperature? These requirements guide the choice within a material group. For components that operate at high temperature for long periods, choose creep-resistant products from the low-alloy steel range. For components subject to wear, choose hardfacing products.
What you want to know Where to find it Chemical composition and mechanical properties The product data sheet Safe handling and fume extraction The safety data sheet Measured values per production batch The material test certificate Storage, drying and re-drying Handling, storage and drying All data sheets and safety data sheets are collected under documentation. If you are unsure how to read a data sheet, see the explanation of a typical data sheet.
In doubt about the combination of base material, welding process and application? Contact us for advice.














